What are the common methods for lubricating open gears?


Release time:

2024-06-28

Common lubrication methods for open gears include:

1.Spraying (relying on an automatic lubrication system):Features a clean environment, good lubrication effect, and ideal sewage discharge. However, it requires a large investment and incurs certain costs.

2.Oil bath lubrication (using gears or oil-coated impellers to deliver lubricant into the mesh): Features low labor intensity, obvious effect, and low cost; however, it is susceptible to dust leakage and contamination, and oil changes result in significant waste.

3.Smearing (manual method): Features low equipment requirements; however, it is unsafe, requires a large labor intensity, and is very costly.

Large open gears are mainly used in some raw material industrial transmission equipment, such as coal mill and ballmill in power plant, rotary kiln in cement plant, ball mill in mine, dryer in chemical industry, drum pulper in paperindustry, etc. These low-speed, heavy-duty gears, which are often accompanied by dust and water vapor, are damagedby rust, wear and other reasons, and then lose contact area, which leads to gear failure.

 

Huashun open gear oil-air lubrication system can remove the high points and peaks on the tooth surface and improve the contact rate of thetooth surface, so as to make the load distribution on the tooth surface more uniform, eliminate the local stressconcentration on the tooth surface and prolong the service life of the gear.

%E7%AC%AC%E4%B8%80%EF%BC%8C%E6%9C%80%EF%BC%8C%E4%BC%98%E7%A7%80%EF%BC%8C%E5%A2%9E%E5%BC%BA%EF%BC%8C%E4%B8%80%E6%B5%81%EF%BC%8C%E5%8D%93%E8%B6%8A%EF%BC%8C%E9%A2%86%E5%85%88%EF%BC%8C%E5%85%88%E8%BF%9B%EF%BC%8C%E5%BC%95%E9%A2%86

Sorry,当前栏目暂无内容!

您可以查看其他栏目或返回 首页

Sorry,The current column has no content!

You can view other columns or return Home